If your Whirlpool washer is stopping during a cycle, it could be due to a variety of reasons. It could be a problem with the washer’s motor, a clogged drain hose, a faulty water inlet valve, or even a worn-out belt. It’s important to diagnose the issue correctly in order to get your washer working again. This guide will help you troubleshoot the most common causes of a Whirlpool washer that keeps stopping.
Why Does My Whirlpool Washer Keep Stopping
There are several possible causes for a Whirlpool washer to stop during a cycle. The most common causes are a power issue, a clogged drain hose, a faulty lid switch, or a faulty timer. You may need to reset the washer or check the power connections, clean the drain hose, or replace the lid switch or timer.
Why Does My Whirlpool Washer Keep Stopping Mid Cycle
1. Check the power supply: Make sure the washer is plugged in and the outlet is receiving power.
2. Check the water supply: Make sure the water supply is turned on and the hoses are connected properly.
3. Check the drain hose: Make sure the drain hose is not clogged or kinked.
4. Check the load size: Make sure the load size is not too large for the washer.
5. Check the cycle selection: Make sure the cycle selection is appropriate for the type of load.
6. Check the timer: Make sure the timer is set correctly and is not stuck in the middle of a cycle.
7. Check the lid switch: Make sure the lid switch is not broken or stuck in the open position.
8. Check the control board: Make sure the control board is functioning properly.
After troubleshooting your Whirlpool washer, it is likely that the issue is related to a faulty lid switch, a clogged drain hose, or a faulty water inlet valve. If the lid switch is faulty, it will cause the washer to stop mid-cycle. If the drain hose is clogged, the water will not be able to drain properly, causing the washer to stop. Finally, if the water inlet valve is faulty, it will not be able to fill the washer with water, causing it to stop mid-cycle. Replacing or repairing any of these components should resolve the issue.