The moisture sensor on a Whirlpool dryer is located inside the dryer drum, near the back wall. It is a small, white, plastic piece with two metal prongs that protrude from the side. The prongs are connected to a wire that runs to the control board. The moisture sensor is responsible for detecting the moisture level in the clothes and adjusting the drying time accordingly. It is important to keep the sensor clean and free from lint to ensure accurate readings.
Where Is The Moisture Sensor On A Whirlpool Dryer
The moisture sensor on a Whirlpool dryer is located in the drum, near the lint filter. The sensor is a small, white plastic strip that is connected to two metal probes. When the dryer is running, the sensor measures the amount of moisture in the air and sends a signal to the control board, which then adjusts the drying time accordingly. This helps to ensure that clothes are not over-dried, which can damage them.
Where Is The Moisture Sensor On A Whirlpool Dryer
1. Unplug the dryer from the power source.
2. Remove the back panel of the dryer.
3. Locate the moisture sensor. It is typically located near the front of the dryer drum.
4. Check the wiring harness for the moisture sensor to ensure it is securely connected.
5. Replace the back panel and plug in the dryer.
In conclusion, the moisture sensor on a Whirlpool dryer is located inside the dryer drum near the lint filter. It is usually a small, round, metal disc that is connected to a wire harness. The moisture sensor helps the dryer to determine when the clothes are dry and when to shut off. Knowing where the moisture sensor is located can help you troubleshoot any issues with your dryer.