The moisture sensor on a Maytag dryer is located inside the dryer drum, near the back. It is typically a small, white plastic piece with two metal prongs. The moisture sensor is used to measure the moisture content of the clothes in the dryer and adjust the drying time accordingly. It is important to keep the moisture sensor clean and free of lint and debris to ensure accurate readings.
Where Is The Moisture Sensor On A Maytag Dryer
The moisture sensor on a Maytag dryer is located inside the dryer drum, near the back wall. It is a metal probe that is connected to the control board. The sensor works by measuring the moisture content in the air inside the dryer drum. When the sensor detects a certain level of moisture, it will signal the control board to shut off the heat and end the drying cycle. This helps to prevent over-drying of clothes and saves energy.
Where Is The Moisture Sensor On A Maytag Dryer
1. Unplug the dryer from the wall outlet.
2. Remove the back panel of the dryer.
3. Locate the moisture sensor, which is typically located near the lint filter.
4. Check the wiring connected to the moisture sensor for any signs of wear or damage.
5. Replace the moisture sensor if necessary.
6. Reattach the back panel and plug the dryer back in.
In conclusion, the moisture sensor on a Maytag dryer is located in the drum of the dryer. It is usually located near the lint filter. The moisture sensor is responsible for detecting the amount of moisture in the air and adjusting the drying cycle accordingly. It is important to keep the moisture sensor clean and free of lint build-up in order to ensure that the dryer is operating at its best.