The moisture sensor on an Amana dryer is located inside the dryer drum. It is a small, round piece of plastic with a metal probe in the center. The probe is connected to a wire that runs to the control board. The sensor is used to measure the moisture content of the clothes and adjust the drying time accordingly. The sensor is located near the bottom of the dryer drum, usually near the back.
Recommended: How To Change Amana Oven From Celsius To Fahrenheit
Where Is The Moisture Sensor On A Amana Dryer
The moisture sensor on an Amana dryer is located on the inside of the dryer drum, near the back. It is a small, round, white plastic part that is connected to two wires. The sensor works by measuring the moisture level in the clothes and then sending a signal to the dryer’s control board to adjust the drying cycle accordingly. This helps to ensure that clothes are not over-dried, which can damage them, or under-dried, which can leave them damp.
Favorite: How To Put Fabric Softener In Amana Washing Machine
Where Is The Moisture Sensor On A Amana Dryer
1. Unplug the dryer from the wall outlet.
2. Remove the back panel of the dryer.
3. Locate the moisture sensor, which is usually located near the heating element.
4. Check the wiring connections to the moisture sensor and make sure they are secure.
5. Test the moisture sensor with a multimeter to make sure it is functioning properly.
6. Replace the back panel and plug the dryer back in.
Suggested: How Old Is My Amana Dishwasher
The moisture sensor on an Amana dryer is typically located inside the dryer drum near the back. It is a small, round, plastic piece that is connected to a wire harness. It is important to check the moisture sensor regularly to ensure it is working properly and that your clothes are being dried properly. If the sensor is not working correctly, it can cause your clothes to come out of the dryer either too wet or too dry.