The moisture sensor on an Amana dryer is typically located on the inside of the dryer drum near the lint filter. This sensor is used to detect when the clothes are dry and to adjust the drying time accordingly. The moisture sensor is an important part of the drying process and helps to ensure that clothes are not over-dried or under-dried. It is important to keep the sensor clean and free of lint and debris to ensure that it is working properly.
Where Is The Moisture Sensor On A Amana Dryer
The moisture sensor on an Amana dryer is located inside the drum, at the back of the dryer near the lint filter. The sensor is a small, round, white plastic strip that is attached to the drum wall. The sensor works by detecting the moisture level in the air as the clothes dry. When the clothes are dry, the sensor sends a signal to the dryer’s control board to shut off the heat. This helps to prevent over-drying and conserve energy.
Where Is The Moisture Sensor On A Amana Dryer
1. Unplug the dryer from the wall outlet.
2. Remove the back panel of the dryer to access the interior.
3. Locate the moisture sensor, which is a small, rectangular box with two wires attached to it.
4. The moisture sensor is usually located on the left side of the dryer drum, near the lint filter.
5. Carefully detach the two wires from the moisture sensor and remove it from the dryer.
6. Replace the back panel of the dryer and plug it back in.
The moisture sensor on an Amana dryer is located inside the dryer drum, near the lint filter. It is a small, round, white plastic disc with two metal contacts. The moisture sensor works in conjunction with the dryer’s thermostat to monitor the amount of moisture in the air and adjust the drying cycle accordingly. This helps to ensure that your clothes come out of the dryer dry and free of wrinkles.