The fuse on a Kenmore dryer is located in the back panel of the dryer. It is typically located near the bottom of the back panel, and is usually a small, white plastic box. The fuse is usually held in place by two screws. To access the fuse, you will need to remove the screws and then pull the fuse out. Once the fuse is removed, you can inspect it for any damage or corrosion. If the fuse is damaged, you will need to replace it with a new one.
Where Is The Fuse On A Kenmore Dryer
The fuse on a Kenmore dryer is typically located either behind the dryer’s rear panel or inside the console. To access the fuse, the rear panel must be removed to expose the wiring. Inside the console, the fuse is usually located beneath the control panel. The fuse should be labeled with the word “Fuse” or “Fuse Link” and is typically a small cylindrical device. If the fuse appears to be damaged or blown, it should be replaced with an exact replacement.
Where Is The Fuse On A Kenmore Dryer
1. Unplug the dryer from the wall outlet.
2. Locate the access panel on the back of the dryer.
3. Remove the screws that secure the access panel to the back of the dryer.
4. Pull the access panel away from the back of the dryer.
5. Locate the fuse box. It will be a small metal box with a hinged lid.
6. Open the fuse box and inspect the fuses.
7. Replace any blown fuses with new ones of the same size and type.
8. Close the fuse box and reattach the access panel.
9. Plug the dryer back into the wall outlet.
In conclusion, the fuse on a Kenmore dryer is typically located behind the access panel on the back of the dryer. The access panel is usually secured with two screws, which must be removed to gain access to the fuse. It is important to note that the fuse should only be replaced with one of the same type and rating as the original fuse. If the fuse is not the correct type or rating, it could cause a fire or other damage to the dryer.