Welcome to the Maytag Washer Troubleshooting Guide! If you’ve noticed your Maytag washer clicking when it’s turned off, you’re not alone. This is a common issue that can be easily fixed. In this guide, we’ll walk you through the most likely causes of the clicking noise and how to fix them. We’ll also provide some tips on how to prevent the issue from happening again in the future. So let’s get started!
Maytag Washer Clicking When Off
If your Maytag washer is clicking when it is off, it could be a number of things. It could be a faulty switch, a loose wire or a faulty timer. You should check the wiring and connections to make sure everything is secure and tight. If the problem persists, you may need to replace the switch, timer, or other parts.
Maytag Washer Clicking When Off
1. Unplug the washer from the wall outlet.
2. Inspect the power cord for any signs of damage.
3. Check the door switch for any signs of wear or damage.
4. Check the lid switch for any signs of wear or damage.
5. Check the water inlet valve for any signs of wear or damage.
6. Check the drain pump for any signs of wear or damage.
7. Check the drive belt for any signs of wear or damage.
8. Check the motor for any signs of wear or damage.
9. Check the timer for any signs of wear or damage.
10. Check the control board for any signs of wear or damage.
11. Check the wiring harness for any signs of wear or damage.
12. Check the suspension system for any signs of wear or damage.
13. Check the water level switch for any signs
In conclusion, the clicking sound coming from a Maytag washer when it is off is most likely caused by a worn out bearing or clutch. It is important to have the washer inspected by a qualified technician to determine the exact cause of the problem and to ensure that the washer is safe to use. If the problem is not addressed, it can cause further damage to the washer and may result in costly repairs.