If you are having trouble with your Kenmore washer, it may be due to a bad suspension rod. To determine which rod is bad, you will need to inspect each rod and look for signs of wear and tear. You should also check for any loose connections or broken parts. If you find any of these signs, then you will need to replace the rod. To do this, you will need to remove the washer’s top panel and locate the suspension rods. Once you have located the rods, you can inspect them for any signs of damage. If you find any damage, then you will need to replace the rod. Be sure to follow the instructions in your washer’s manual for replacing the suspension rod.
How To Tell Which Suspension Rod Is Bad On My Kenmore Washer
If you suspect that one or more of the suspension rods on your Kenmore washer is bad, there are a few ways to tell. First, check for any visible signs of damage or wear on the rods. If the rod is bent or cracked, it should be replaced. Additionally, if the washer is not level or is making excessive noise during operation, this could be an indication that a suspension rod needs to be replaced. Finally, if the washer is shaking or vibrating more than normal during operation, this could also be an indication that a suspension rod needs to be replaced.
How To Tell Which Suspension Rod Is Bad On My Kenmore Washer
1. Unplug the washer from the power source and turn off the water supply.
2. Remove the access panel to the suspension rods.
3. Inspect the suspension rods for any signs of damage, such as cracks, bends, or rust.
4. Check the tension of the suspension rods by pushing down on them. If one of the rods feels loose or does not have the same tension as the other rods, it is likely the bad one.
5. Replace the bad suspension rod with a new one.
6. Reinstall the access panel and plug the washer back in.
After inspecting the suspension rods, it is important to look for signs of wear and tear on the rods. If the rods are bent or cracked, they should be replaced immediately. If the rods are loose or the washer is not level, they should also be replaced. Additionally, if the washer is making loud noises or vibrating excessively, the suspension rods may need to be replaced. Finally, if the washer is not spinning or agitating properly, the suspension rods may be the cause. By inspecting the suspension rods and checking for signs of wear and tear, you can tell which suspension rod is bad on your Kenmore washer.