If your Frigidaire washer is not spinning or agitating properly, it could be due to a bad suspension rod. To determine if this is the case, you will need to inspect the suspension rods. Suspension rods are located underneath the washer and help to support the washer tub. To inspect the suspension rods, you will need to unplug the washer and tilt it back to gain access to the underside. Look for any signs of damage, such as bent or broken rods. If the rods appear to be in good condition, then you may need to replace them. If the rods are bent or broken, then they need to be replaced in order to ensure proper operation of the washer.
How To Tell Which Suspension Rod Is Bad On My Frigidaire Washer
If you suspect that one of the suspension rods on your Frigidaire washer is bad, there are a few ways to tell. First, check the rods for any signs of visible damage, such as cracks or bends. If there is no visible damage, you can check the tension of the rods by pushing down on the washer tub. If the tub does not move, the rod may be too tight. If the tub moves too much, the rod may be too loose. You can also check the rods for any signs of corrosion or rust, which can indicate that the rod is wearing out. If you find any of these signs, it is best to replace the rod to ensure your washer is running properly.
How To Tell Which Suspension Rod Is Bad On My Frigidaire Washer
1. Unplug the washer from the power source.
2. Remove the back panel of the washer to access the suspension rods.
3. Visually inspect the suspension rods for any signs of wear or damage.
4. Check the suspension rods for any loose or broken parts.
5. Check the suspension rods for any signs of rust or corrosion.
6. Check the suspension rods for any signs of bending or warping.
7. Check the suspension rods for any signs of misalignment.
8. Check the suspension rods for any signs of excessive vibration.
9. If any of the suspension rods appear to be in bad condition, replace them with new ones.
After inspecting the suspension rods on your Frigidaire washer, you should be able to tell which one is bad. If the rod is bent, cracked, or has any other visible damage, it is likely the culprit. Additionally, if the washer is still shaking or vibrating after replacing the shock absorbers, it is likely that one of the suspension rods is bad and needs to be replaced.