Taking the timer off a Haier washer machine is a relatively simple process. Before beginning, make sure to unplug the washer and shut off the water supply to the machine. You will need a Phillips head screwdriver and a pair of pliers. Begin by locating the timer control knob on the front of the washer. This knob is usually located near the top of the control panel. Use the screwdriver to remove the screws that secure the knob to the control panel. Once the screws are removed, gently pull the knob off the control panel. You will then see two wires connected to the back of the knob. Use the pliers to carefully disconnect the wires from the back of the knob. Once the wires are disconnected, the timer can be removed from the washer.
How To Take The Timer Off A Haier Washer Machine
Taking the timer off of a Haier washer machine is a relatively simple process. First, unplug the washer from the wall outlet. Then, locate the timer knob on the front of the machine and remove the knob by pulling it straight off. Next, remove the two screws that secure the timer to the front of the washer. Carefully lift the timer off of the washer and disconnect the wiring harness from the back of the timer. Finally, replace the timer with a new one and reattach the wiring harness, screws, and knob.
How To Take The Timer Off A Haier Washer Machine
1. Unplug the washer from the wall outlet.
2. Open the washer lid and locate the timer knob.
3. Turn the timer knob counterclockwise to the off position.
4. Remove the timer knob by pulling it off the timer shaft.
5. Unscrew the two screws that hold the timer in place.
6. Pull the timer out of the washer.
7. Disconnect the wires from the timer.
8. Replace the timer with a new one, if necessary.
9. Reconnect the wires to the new timer.
10. Secure the timer in place with the two screws.
11. Reattach the timer knob and turn it to the off position.
12. Plug the washer back into the wall outlet.
To take the timer off a Haier washer machine, first locate the timer knob on the control panel. Turn the knob counterclockwise until it stops. This will disengage the timer and allow the washer to run without any time constraints. Once the timer is disengaged, the washer can be used normally.