Reversing the door on a Whirlpool Duet dryer is a simple process that requires only a few tools and a few minutes of your time. Before you begin, make sure that you have the necessary tools, including a Phillips head screwdriver, a flat head screwdriver, and a pair of pliers. Once you have the tools, you can begin the process of reversing the door.
First, unplug the dryer from the wall. Then, use the Phillips head screwdriver to remove the screws from the hinges that hold the door in place. Next, use the flat head screwdriver to remove the hinge pins from the hinges. Once the pins are removed, you can then remove the door from the dryer.
Next, you will need to rotate the hinges 180 degrees. To do this, use the pliers to loosen the screws on the hinges, then rotate the hinges and tighten the screws back into place. Finally, reattach the
How To Reverse Door On Whirlpool Duet Dryer
To reverse the door on a Whirlpool Duet dryer, first unplug the dryer from the wall. Then, remove the screws that hold the door hinges in place. Remove the door and re-attach the hinges to the opposite side. Lastly, re-attach the screws and plug the dryer back in.
How To Reverse Door On Whirlpool Duet Dryer
1. Unplug the dryer from the wall outlet.
2. Remove the screws that hold the top panel of the dryer in place.
3. Lift the top panel off and set aside.
4. Remove the screws that hold the front panel of the dryer in place.
5. Lift the front panel off and set aside.
6. Unplug the wiring harness from the door switch.
7. Remove the screws that hold the door in place.
8. Lift the door off and set aside.
9. Flip the door over and reattach it to the dryer.
10. Reattach the wiring harness to the door switch.
11. Reattach the front panel to the dryer.
12. Reattach the top panel to the dryer.
13. Plug the dryer back into the wall outlet.
The process of reversing the door on a Whirlpool Duet dryer is relatively straightforward and can be completed in a few simple steps. First, you’ll need to remove the screws that hold the door in place. Then, you’ll need to remove the door itself and disconnect the wires. Once the wires are disconnected, you can then reverse the hinges and reattach the door. Finally, you’ll need to reconnect the wires and replace the screws to secure the door. Following these steps should help you successfully reverse the door on your Whirlpool Duet dryer.