If you need to reset your Maytag top load washer to its factory settings, you can do so in a few easy steps. First, make sure the washer is powered off and unplugged from the wall. Then, locate the control panel on the back of the washer. On the control panel, you will find a small button labeled “Reset”. Press and hold the reset button for at least five seconds. After five seconds, the washer will be reset to its factory settings. You can now plug the washer back in and turn it on. Your Maytag top load washer is now reset to its factory settings.
How To Reset Maytag Top Load Washer To Factory Settings
To reset your Maytag top-load washer to factory settings, press and hold the “End of Cycle” button for at least 3 seconds until the control panel lights flash. This will reset the washer to its factory settings.
Popular: How To Clean Maytag Top Load Washer Filter
How To Reset Maytag Top Load Washer To Factory Settings
1. Unplug the washer from the power source.
2. Press and hold the “Start/Pause” button for three seconds.
3. Press the “Power” button to turn the washer off.
4. Press and hold the “Start/Pause” button for three seconds.
5. Press the “Power” button to turn the washer on.
6. Press the “Start/Pause” button to start the reset process.
7. The washer will begin to run through a series of tests and will reset itself to the factory settings.
8. Once the reset is complete, the washer will beep and the lights will flash.
9. Plug the washer back into the power source.
Suggested: How To Bypass Cleaning Cycle On Maytag Washer
Resetting a Maytag top load washer to factory settings is a simple process. All you need to do is unplug the washer from the wall, wait for 30 seconds, and then plug it back in. This will reset all the settings back to their original factory settings. If the washer is still not working properly, you may need to perform a more advanced reset by pressing and holding the Start/Pause and the Cancel/Drain buttons at the same time for 3 seconds. This should reset the washer to its original factory settings.