Replacing the tub bearing on a Maytag washer is a job that requires some knowledge and skill. The tub bearing is an important component of the washer, and it is responsible for supporting the tub and allowing it to spin freely. If the bearing is worn out, it can cause the washer to become noisy or even fail to spin. Replacing the tub bearing is a relatively simple job, but it does require some special tools and knowledge. This guide will provide you with the steps necessary to replace the tub bearing on a Maytag washer.
How To Replace Tub Bearing On Maytag Washer
1. Unplug the washer from the power source and turn off the water supply.
2. Remove the back panel of the washer to access the tub bearing.
3. Remove the old tub bearing and any other parts that may be attached to it.
4. Clean the area around the bearing and make sure there is no debris or dirt present.
5. Install the new bearing, making sure it is properly aligned and secured.
6. Reattach any other parts that were removed.
7. Replace the back panel of the washer.
8. Reconnect the power source and turn on the water supply.
9. Test the washer to make sure it is working properly.
Replacing the tub bearing on a Maytag washer is a relatively simple process that requires basic mechanical knowledge and a few tools. The first step is to disconnect the power and water supply to the washer. Next, the cabinet must be removed to access the tub bearing. Then, the old bearing must be removed and the new bearing must be installed. Finally, the cabinet must be reattached and the power and water supply reconnected. With the right tools and a bit of patience, replacing the tub bearing on a Maytag washer can be done in a few hours.