Replacing the front control board on a Kitchenaid microwave is a relatively simple process that can be completed in just a few steps. Before beginning the process, it is important to make sure that the power to the microwave is turned off. Once the power is turned off, the next step is to remove the outer casing of the microwave. This can be done by removing the screws that hold the casing in place. Once the screws are removed, the outer casing can be carefully lifted off of the microwave. With the outer casing removed, the next step is to locate the front control board. This will be found on the inside of the microwave, typically near the top. Once the front control board has been located, the next step is to disconnect the wires from the board. This can be done by gently pulling the wires away from the board. Once the wires are disconnected, the board can be removed from the microwave. The new control board can then be installed in place of the old one,
How To Replace The Front Control Board On A Kitchenaid Microwave
Replacing the front control board on a Kitchenaid microwave is a relatively straightforward process. First, unplug the microwave from the wall outlet and remove the screws from the exterior of the unit. Then, remove the faceplate and disconnect the wiring harness from the old control board. Next, install the new control board and reconnect the wiring harness. Finally, reattach the faceplate and screws, and plug the microwave back in. With a few simple steps, you can quickly and easily replace the front control board on a Kitchenaid microwave.
How To Replace The Front Control Board On A Kitchenaid Microwave
1. Unplug the microwave from the wall outlet.
2. Remove the screws that secure the microwave’s outer cabinet and lift off the cabinet.
3. Locate the control board and disconnect the wiring harness from the board.
4. Remove the screws that secure the control board to the microwave.
5. Install the new control board, making sure to connect the wiring harness.
6. Secure the control board to the microwave with the screws.
7. Replace the outer cabinet and secure with screws.
8. Plug the microwave back into the wall outlet.
Replacing the front control board on a Kitchenaid microwave is a relatively simple process that can be completed in a few steps. First, you should unplug the microwave and remove the screws from the control panel. Next, you should disconnect the wires from the control board and remove it from the microwave. Finally, you should install the new control board and reconnect the wires before replacing the control panel and plugging the microwave back in. With these steps, you can easily replace the front control board on a Kitchenaid microwave.