Replacing the heating element in an Electrolux dryer is a fairly simple task that can be done with minimal tools and a bit of know-how. This guide will walk you through the steps of replacing the heating element in an Electrolux dryer. Before beginning, make sure you have the correct replacement part for your model of dryer. You will also need a Phillips screwdriver and a pair of needle-nose pliers.
First, unplug the dryer from the wall outlet. Then, remove the back panel of the dryer. This is usually done by removing the screws on the back of the dryer. Once the panel is removed, you will be able to access the heating element.
Using the pliers, carefully remove the wires connected to the heating element. Once the wires are removed, you can unscrew the heating element from the dryer.
How To Replace Heating Element In Electrolux Dryer
Replacing the heating element in an Electrolux dryer is a relatively simple process that can be done in a few steps. First, unplug the dryer and remove the back panel. Then, locate the heating element and disconnect the wires connected to it. Next, remove the screws holding the heating element in place and take it out. Finally, install the new heating element and reconnect the wires. Replace the back panel and plug the dryer back in. Test the dryer to make sure the new heating element is working properly.
How To Replace Heating Element In Electrolux Dryer
1. Unplug the dryer from the wall and turn off the gas supply if applicable.
2. Remove the back panel of the dryer to access the heating element.
3. Disconnect the wires from the heating element.
4. Remove the mounting screws and take out the old heating element.
5. Install the new heating element and secure with the mounting screws.
6. Reconnect the wires to the new heating element.
7. Replace the back panel and plug the dryer back in.
8. Turn on the gas supply if applicable and test the dryer.
The process of replacing the heating element in an Electrolux dryer is not difficult, but it does require some basic knowledge of electrical wiring and tools. It is important to ensure that the power is disconnected from the dryer before beginning. Once the power is disconnected, it is necessary to remove the back panel of the dryer and locate the heating element. The heating element needs to be disconnected from the wiring and then the new element can be connected. Once the new element is connected, the back panel can be replaced and the power reconnected. With the proper tools and knowledge, replacing a heating element in an Electrolux dryer is a straightforward process.