Replacing the belt on a Maytag washer is a relatively simple task that can be completed in a few steps. This guide will walk you through the process of replacing the belt on a Maytag washer. Before beginning, make sure that the power to the washer is turned off and that the water supply is disconnected. You will also need a new belt and a Phillips-head screwdriver. Once you have gathered the necessary tools, you can begin the process of replacing the belt.
How To Replace Belt On Maytag Washer
Replacing a belt on a Maytag washer is a relatively simple process that can be completed in a few steps. First, unplug the washer and remove the back panel to gain access to the belt. Then, remove the old belt and replace it with the new one. Make sure the belt is properly aligned and tensioned, and then reattach the back panel. Finally, plug the washer back in and test it to make sure it is working properly.
How To Replace Belt On Maytag Washer
1. Unplug the washer from the wall outlet and shut off the water supply.
2. Remove the front panel of the washer by unscrewing the screws located at the bottom.
3. Remove the old belt from the motor pulley and the drive pulley.
4. Place the new belt around the motor pulley and the drive pulley.
5. Make sure the belt is properly aligned and tensioned.
6. Reinstall the front panel and screws.
7. Plug the washer back into the wall outlet and turn on the water supply.
8. Test the washer to make sure the belt is properly aligned and tensioned.
Replacing the belt on a Maytag washer is a relatively simple process that can be completed in a few steps. First, unplug the washer and remove the front panel. Next, remove the old belt and replace it with the new one. Finally, reassemble the washer and plug it back in. With the right tools and a bit of patience, replacing the belt on a Maytag washer is a straightforward task that can be completed in a short amount of time.