Replacing the belt on a Kenmore washer is a relatively simple process that can be completed in a few steps. Before beginning, make sure to unplug the washer from the power source and turn off the water supply. You will also need a set of wrenches and a new belt. Once you have all the necessary tools, you can begin the process of replacing the belt. First, remove the screws that hold the back panel of the washer in place. Then, carefully remove the old belt from the pulley system and discard it. Next, place the new belt around the pulley system and make sure it is properly aligned. Finally, reattach the back panel and tighten the screws. Once you have completed these steps, your Kenmore washer should be ready to use.
How To Replace Belt On Kenmore Washer
Replacing the belt on a Kenmore washer is a relatively simple job that can be done in a few steps. First, unplug the washer and remove the front panel. Next, remove the old belt and inspect the pulleys for any damage. If the pulleys are damaged, they should be replaced. Once the pulleys are in good condition, place the new belt around the pulleys and then re-install the front panel. Finally, plug the washer back in and test it out to make sure the belt is working correctly.
How To Replace Belt On Kenmore Washer
1. Unplug the washer from the power source.
2. Remove the access panel from the bottom of the washer.
3. Remove the old belt from the motor pulley and the drive pulley.
4. Place the new belt around the motor pulley and the drive pulley.
5. Pull the belt tight and make sure it is properly aligned.
6. Replace the access panel and plug the washer back in.
7. Run a test cycle to make sure the belt is working properly.
Replacing the belt on a Kenmore washer is not a difficult task and can be completed in a few easy steps. First, you must unplug the washer and remove the front panel. Then, you will need to remove the old belt and replace it with the new one. Finally, you will need to reassemble the washer and plug it back in. With a few simple steps, you can easily replace the belt on your Kenmore washer and get it back to running like new again.