If you have a Maytag MMV1164WB 1.6 cu. ft. over-the-range microwave oven and need to repair the sensor switch, you have come to the right place. This guide will provide you with the necessary steps to repair the sensor switch on your microwave oven. Before beginning, make sure that you have all the necessary tools and materials needed to complete the repair. You will need a Phillips head screwdriver, a flat head screwdriver, and a replacement sensor switch. Once you have all the necessary tools and materials, you can begin the repair.
How To Repair Sensor Switch On Maytag Mmv1164Wb 1.6 Cu. Ft. Over-The-Range Microwave Oven.
If the sensor switch on your Maytag MMV1164WB 1.6 cu. ft. over-the-range microwave oven is not working correctly, you will need to replace it. You can purchase a replacement sensor switch from an appliance parts store or online. Once you have the replacement part, you will need to disconnect the power to the microwave and remove the cabinet to access the switch. Once you have access to the switch, you will need to disconnect the wires from the old switch and then connect them to the new switch. Finally, you will need to reassemble the cabinet and restore power to the microwave.
How To Repair Sensor Switch On Maytag Mmv1164Wb 1.6 Cu. Ft. Over-The-Range Microwave Oven.
1. Unplug the microwave from the power source.
2. Remove the screws from the top of the microwave to access the interior.
3. Locate the sensor switch and remove it from the microwave.
4. Inspect the sensor switch for any signs of damage or corrosion.
5. If the sensor switch is damaged or corroded, replace it with a new one.
6. Reinstall the sensor switch and secure it with the screws.
7. Plug the microwave back into the power source and test the sensor switch.
In conclusion, repairing the sensor switch on the Maytag MMV1164WB 1.6 cu. ft. over-the-range microwave oven requires a few simple steps. First, unplug the unit and remove the control panel. Next, remove the screws that hold the sensor switch in place and disconnect the wires. Finally, install the new sensor switch, reconnect the wires, and secure the control panel back in place. With these steps, the sensor switch should be successfully repaired.