Removing the start relay on a Maytag freezer is a relatively simple process that can be completed in a few steps. The start relay is responsible for controlling the compressor motor and is located behind the control panel. To remove the start relay, you will need a Phillips head screwdriver, a flat head screwdriver, and a pair of needle nose pliers. First, unplug the freezer from the wall outlet and remove the control panel cover. Next, locate the start relay and use the Phillips head screwdriver to remove the screws that hold it in place. Once the screws are removed, you can use the flat head screwdriver to gently pry the start relay away from the control panel. Finally, use the needle nose pliers to remove the wires connected to the start relay and then set the start relay aside.
How To Remove The Start Relay On Maytag Freezer
To remove the start relay on a Maytag freezer, you will need to access the back panel of the freezer and locate the start relay. Once you have located the start relay, you will need to unplug the wires connected to it. Then, you can use a screwdriver to unscrew the screws that are holding the start relay in place. Once the screws have been removed, you can pull the start relay out of the freezer.
How To Remove The Start Relay On Maytag Freezer
1. Unplug the freezer from the power source.
2. Locate the start relay. It will be located on the back of the freezer, near the compressor.
3. Disconnect the wires from the start relay.
4. Remove the screws that hold the start relay in place.
5. Pull the start relay out of the freezer.
6. Replace the start relay with a new one.
7. Reconnect the wires to the new start relay.
8. Secure the start relay with the screws.
9. Plug the freezer back into the power source.
Removing the start relay on a Maytag freezer is a relatively easy task that can be completed in just a few simple steps. First, unplug the freezer and locate the start relay. Then, remove the screws that hold the relay in place and disconnect the wiring harness. Finally, remove the relay and replace it with a new one. With the right tools and a little bit of patience, anyone can complete this task.