Removing the drum from your Kenmore dryer is a relatively simple process that can be completed in a few steps. Before beginning, make sure to unplug the dryer and turn off the gas supply. You will need a Phillips head screwdriver and a pair of pliers. Begin by removing the lint filter and the lint trap door. Then, remove the screws that hold the top panel in place. Once the top panel is removed, you will be able to access the drum. There are two screws at the back of the drum that need to be removed. Once the screws are removed, you can lift the drum out of the dryer. Make sure to be careful when handling the drum as it is heavy. Once the drum is removed, you can proceed with the repair.
How To Remove Drum From Kenmore Dryer
Removing a drum from a Kenmore dryer is a simple process that requires just a few tools. First, unplug the dryer and remove the lint filter. Then, remove the two screws at the back of the dryer that hold the top panel in place. Lift the top panel off and set it aside. Next, remove the two screws at the front of the dryer that hold the front panel in place. Lift the front panel off and set it aside. Now, you can access the drum and the belt. Disconnect the belt from the motor and the drum, and then remove the four screws that hold the drum in place. Finally, lift the drum out of the dryer and set it aside.
How To Remove Drum From Kenmore Dryer
1. Unplug the dryer from the power source.
2. Remove the lint filter and the lint filter housing.
3. Remove the screws from the front panel of the dryer.
4. Slide the front panel off and set aside.
5. Disconnect the wiring harness from the drum and the motor.
6. Remove the screws that hold the drum in place.
7. Carefully lift the drum out of the dryer and set aside.
To remove the drum from a Kenmore dryer, first disconnect the power and remove the lint filter. Then, remove the screws that hold the top panel in place and lift the top panel off. Disconnect the wires from the door switch and remove the screws that hold the front panel in place. Pull the front panel off and disconnect the wires from the blower housing. Remove the screws that hold the drum in place and lift the drum out. Finally, remove the rear drum seal and replace it with a new one. With these steps, the drum can be safely and effectively removed from the Kenmore dryer.