Removing the agitator from a Whirlpool washer is a relatively simple task that can be completed with a few basic tools. Before beginning the process, make sure to unplug the power cord from the wall outlet and turn off the water supply to the washer. Once this is done, you will need to gather a few tools, including a flathead screwdriver, a pair of pliers, and a bucket. With these tools in hand, you can begin the process of removing the agitator. Start by removing the fabric softener cap located on the top of the agitator. Next, use the flathead screwdriver to remove the screws that hold the agitator in place. Once the screws are removed, use the pliers to remove the clips that hold the agitator in place. Finally, lift the agitator out of the washer and place it in the bucket.
How To Remove Agitator From Whirlpool Washer
1. Unplug the washer from the wall outlet.
2. Place a towel on the floor beneath the washer to catch any water that may drip from the agitator.
3. Locate the agitator bolt at the bottom of the agitator.
4. Use a socket wrench to loosen and remove the agitator bolt.
5. Lift the agitator straight up and out of the washer.
6. Clean the agitator and the area where it was removed from.
7. Replace the agitator bolt and tighten it with the socket wrench.
8. Plug the washer back into the wall outlet.
How To Remove Agitator From Whirlpool Washer
Removing the agitator from a Whirlpool washer is a relatively simple task that can be accomplished in a few steps. First, unplug the washer and remove the fabric softener dispenser, if applicable. Next, use a flathead screwdriver to remove the agitator cap and the bolt underneath. Finally, lift the agitator straight up to remove it. With these steps, you can easily remove the agitator from your Whirlpool washer.