Putting your Kenmore dishwasher into diagnostic mode is a great way to troubleshoot any issues you may be having with the appliance. Diagnostic mode allows you to access the dishwasher’s error codes, which can help you identify the problem and determine the best course of action. The process for entering diagnostic mode is fairly simple, but it does require a few steps. Here’s how to do it:
1. Start by unplugging the dishwasher from the wall outlet.
2. Press and hold the “Start/Reset” button for 5 seconds.
3. While still holding the “Start/Reset” button, plug the dishwasher back in.
4. Release the “Start/Reset” button and press it again.
5. The dishwasher will now enter diagnostic mode.
6. You can now access the error codes by pressing the “Cancel/Drain” button.
How To Put Kenmore Dishwasher In Diagnostic Mode
Kenmore dishwashers can be put into diagnostic mode to help troubleshoot and diagnose any issues. To do this, the user must first locate the diagnostic mode button. This is usually located on the inside of the door, near the top. Once the button is located, the user must press and hold it down for three to five seconds. This will put the dishwasher into diagnostic mode. The user can then run a diagnostic cycle and review any error codes that may appear. This will help them identify and troubleshoot any issues they may be having with their dishwasher.
How To Put Kenmore Dishwasher In Diagnostic Mode
1. Unplug the dishwasher from the power source.
2. Press and hold the “Normal Wash” and “Heated Dry” buttons simultaneously.
3. Plug the dishwasher back into the power source.
4. Keep the buttons pressed until the “Clean” light starts to blink.
5. Release the buttons.
6. Press the “Normal Wash” button once.
7. Press the “Heated Dry” button once.
8. The “Clean” light will blink twice to indicate that the dishwasher is in diagnostic mode.
In conclusion, putting a Kenmore dishwasher in diagnostic mode is a relatively simple process. All that is required is to press and hold the heated dry and normal buttons for three seconds, then press the cancel button twice. This will put the dishwasher into diagnostic mode, allowing you to view any error codes that may be present. It is important to note that this process will not reset any error codes, but will simply allow you to view them.