If you need to repair your Maytag washer, the first step is to open the washer. This can be done by removing the screws on the back of the washer and then lifting the top panel off. Be sure to take note of where the screws were located so you can replace them when you are finished. Once the top panel is removed, you should be able to access the internal components of the washer. You will then be able to diagnose and repair the problem.
How To Open A Maytag Washer For Repair
1. Unplug the washer from the wall outlet.
2. Remove the screws that secure the back panel of the washer.
3. Lift the back panel up and off the washer.
4. Remove the screws that secure the top panel of the washer.
5. Lift the top panel up and off the washer.
6. Remove the screws that secure the front panel of the washer.
7. Pull the front panel off the washer.
8. Disconnect the wiring harnesses from the control board and the motor.
9. Remove the screws that secure the motor to the washer.
10. Lift the motor out of the washer.
11. Remove the screws that secure the control board to the washer.
12. Lift the control board out of the washer.
13. Inspect the components and replace any defective parts.
In conclusion, opening a Maytag washer for repair is a relatively straightforward process. First, unplug the washer from the wall and turn off the water supply. Then, remove the screws from the back panel and lift off the panel. After that, remove the screws from the front of the washer and lift off the top panel. Finally, remove the screws from the sides of the washer and lift off the sides. With these steps, you should be able to access the internal components of the washer and perform any necessary repairs.