How To Install A Belt On A Whirlpool Dryer

Installing a belt on a Whirlpool dryer is a relatively simple process. With the right tools and a little bit of patience, you can have your dryer up and running again in no time. Before you begin, make sure you have the correct belt for your model of Whirlpool dryer. You will also need a pair of pliers, a flathead screwdriver, and a Phillips head screwdriver. Once you have all the necessary tools, you can begin the installation process.

First, you will need to locate the belt tensioner on the back of the dryer. Once you have found the tensioner, use a flathead screwdriver to loosen the tensioner and remove the old belt. Then, take the new belt and loop it around the drum and the motor pulley. Make sure the belt is properly aligned and that it is tight. Finally, use the pliers to reattach the tensioner and secure the belt in place.

 

 

How To Install A Belt On A Whirlpool Dryer

1. Unplug the dryer from the wall outlet.

2. Remove the front panel of the dryer by removing the screws on the inside of the door.

3. Remove the drum from the dryer by unscrewing the screws that hold it in place.

4. Locate the belt tensioner and remove the old belt.

5. Place the new belt around the drum and the belt tensioner.

6. Reinstall the drum and the front panel.

7. Plug the dryer back into the wall outlet.

8. Test the dryer to make sure the belt is working properly.

Installing a belt on a whirlpool dryer is a relatively simple process that can be completed in just a few steps. First, you need to unplug the dryer and remove the front panel. Then, you should remove the old belt and replace it with the new one. After that, you should reinstall the front panel and plug the dryer back in. Finally, you should test the dryer to make sure that the belt is functioning properly. With these steps, you can easily install a belt on a whirlpool dryer.