If your Whirlpool washer is displaying an “FL” code, it means that there is a problem with the water flow in your washer. This issue is usually caused by a clogged filter, a kinked hose, or a faulty water inlet valve. To fix this issue, you will need to inspect the filter, hoses, and water inlet valve for any problems. Once you have identified the source of the problem, you can then take the necessary steps to resolve it. This guide will provide you with the information you need to fix the FL code on your Whirlpool washer.
How To Fix Fl Code On Whirlpool Washer
1. Unplug the washer from the power source.
2. Check the water hoses and make sure they are connected properly and are not kinked or leaking.
3. Check the drain hose and make sure it is not clogged or kinked.
4. Check the water pressure and make sure it is sufficient.
5. Check the water inlet valve and make sure it is not clogged.
6. Check the control board and make sure it is not damaged.
7. Check the wiring and make sure it is connected properly.
8. Check the motor and make sure it is working properly.
9. Check the belt and make sure it is not worn or broken.
10. Plug the washer back into the power source and reset the cycle.
How To Fix Fl Code On Whirlpool Washer
The best way to fix FL code on a Whirlpool washer is to check the drain pump filter for any blockages and clean it if necessary. If the filter is clear, then the next step is to check the drain hose for any kinks or blockages. If the hose is clear, the next step is to check the drain pump for any damage or debris. If the pump is damaged, it should be replaced. Finally, if the issue persists, it is recommended to contact a professional appliance repair technician to diagnose and repair the issue.