If you are experiencing an E3 error on your Whirlpool dehumidifier, it can be a bit of a challenge to figure out how to fix it. Fortunately, there are some steps you can take to troubleshoot and hopefully resolve the issue. First, check the air filter and make sure it is clean and free of any obstructions. Next, check the condensate drain hose and make sure it is not blocked or kinked. If the hose is blocked, you may need to clean it out or replace the Whirlpool dehumidifier hose. Additionally, make sure the water bucket is empty and that the float switch is working properly. Lastly, you may need to reset the dehumidifier by unplugging it and then plugging it back in. Following these steps should help you resolve the E3 error on your Whirlpool dehumidifier.
Suggested: What Does E1 Mean On A Whirlpool Dehumidifier
How To Fix E3 Error On Whirlpool Dehumidifier
The E3 error code on a Whirlpool Dehumidifier indicates that the unit’s air filter is blocked. To fix this, you will need to remove the air filter and clean it thoroughly with a vacuum cleaner or a damp cloth. Once the filter is clean, replace it and restart the dehumidifier. If the error code persists, then you may need to contact a technician for further assistance.
How To Fix E3 Error On Whirlpool Dehumidifier
1. Unplug the dehumidifier from the wall outlet.
2. Check the air filter and clean or replace it if necessary.
3. Check the drain hose and make sure it is not clogged or kinked.
4. Check the water bucket and make sure it is properly seated in the dehumidifier.
5. Check the fan motor and make sure it is running properly.
6. Check the temperature sensor and make sure it is working properly.
7. Check the control board and make sure it is functioning properly.
8. Plug the dehumidifier back into the wall outlet and turn it on.
9. Check the error code and see if it has been cleared. If not, contact a qualified service technician for further assistance.
The best way to fix the E3 error on a Whirlpool dehumidifier is to first check the air filter and make sure it is clean. If the filter is dirty, replace it and then reset the dehumidifier. If the filter is clean, then reset the dehumidifier and check the fan motor for any obstructions. If the fan motor is blocked, remove the obstruction and then reset the dehumidifier. If the fan motor is not blocked, then check the evaporator coil and make sure it is not frozen or clogged. If the evaporator coil is frozen or clogged, then thaw it or clean it and then reset the dehumidifier. If all of these steps have been taken and the E3 error persists, then the dehumidifier may need to be serviced by a qualified technician.