If you need to disassemble a Kenmore washer, it is important to understand the basics of the process. First, you should unplug the washer from the wall and shut off the water supply. Then, you will need to remove the cabinet panel and the top panel to access the internal components. Next, you will need to disconnect the water hoses and the electrical wiring. Finally, you can begin to remove the internal components, such as the motor, the pump, and the agitator. Make sure to take notes or pictures of the parts as you take them apart so you can easily remember how to put them back together.
How To Disassemble A Kenmore Washer
To disassemble a Kenmore washer, first unplug the washer and turn off the water supply. Remove the screws from the back of the washer and remove the back panel. Disconnect the water hoses, drain hose, and electrical connections. Remove the screws from the top of the washer and lift off the top. Remove the screws from the front panel and lift it off. Remove the screws from the tub and lift it off. Remove the agitator and the drive block. Remove the screws from the motor and lift it off. Finally, remove the screws from the transmission and lift it off. Once the washer is disassembled, it can be cleaned and reassembled.
How To Disassemble A Kenmore Washer
1. Unplug the washer from the wall.
2. Remove the back panel of the washer by unscrewing the screws.
3. Unscrew the screws that hold the top panel in place and remove the top panel.
4. Unscrew the screws that hold the control panel in place and remove the control panel.
5. Unscrew the screws that hold the agitator in place and remove the agitator.
6. Unscrew the screws that hold the outer tub in place and remove the outer tub.
7. Unscrew the screws that hold the inner tub in place and remove the inner tub.
8. Unscrew the screws that hold the motor in place and remove the motor.
9. Unscrew the screws that hold the pump in place and remove the pump.
In conclusion, disassembling a Kenmore washer is a straightforward process that requires basic tools and a bit of patience. Start by unplugging the washer and turning off the water supply. Then, remove the cabinet and the top panel to gain access to the inner workings of the washer. After that, remove the agitator, the drive belt, and the motor. Finally, unscrew the mounting screws and remove the tub. With the tub removed, you can now access the remaining components and replace any faulty parts.