If you have a Kenmore refrigerator, you may find it necessary to disable the alarm that sounds when the door is left open for too long. Disabling the alarm is a simple process that can be done in a few steps. This guide will show you how to disable the alarm on your Kenmore refrigerator.
First, locate the control panel on the refrigerator. It is typically located on the top of the refrigerator, near the door. You will see a button labeled “Alarm”. Press and hold this button for several seconds until the alarm stops sounding. Once the alarm is silenced, the indicator light on the control panel should turn off. This indicates that the alarm has been disabled. If the light remains lit, press and hold the “Alarm” button again until the light turns off. Your Kenmore refrigerator is now set to not sound an alarm when the door is left open for too long.
How To Disable Alarm On Kenmore Refrigerator
Disabling the alarm on a Kenmore refrigerator is a simple process that can be done in a few steps. First, locate the alarm control panel on the inside of the refrigerator door. It is usually located near the top of the door. Next, press and hold the Alarm Off button for three seconds. This will turn off the alarm and the alarm indicator light will turn off. Finally, close the door and the alarm will remain off until it is reset. If the alarm continues to sound, it may be necessary to reset the refrigerator by unplugging it and plugging it back in.
How To Disable Alarm On Kenmore Refrigerator
1. Open the refrigerator door and locate the control panel.
2. Press and hold the “Alarm” button for 3 seconds until the alarm sound stops.
3. Press the “Alarm” button again to turn off the alarm light.
4. Close the refrigerator door.
In conclusion, disabling the alarm on a Kenmore refrigerator is a relatively simple process. To do this, press and hold the alarm button for three seconds until the alarm stops beeping. This will turn off the alarm and the light will turn off. If the alarm does not stop beeping, unplug the refrigerator for a few minutes and then plug it back in. This should reset the alarm and allow you to disable it.