If your LG dryer is not working properly or you need to clear the code, there are a few steps you can take to reset the dryer. To clear the code on your LG dryer, you will need to unplug the dryer from the wall, wait for 10 minutes, then plug it back in. Once the dryer is plugged back in, press and hold the “Start/Pause” button for 5 seconds. This should reset the dryer and clear the code. If the code does not clear, you may need to contact LG customer service for further assistance.
How To Clear Cl Code On Lg Dryer
To clear the CL code on an LG dryer, press and hold the “Start/Pause” button for 3 seconds. This will reset the dryer and clear the CL code.
How To Clear Cl Code On Lg Dryer
1. Unplug the dryer from the wall outlet.
2. Remove the back panel of the dryer.
3. Locate the control board, which is usually located on the left side of the dryer.
4. Locate the CL code reset button, which is usually a small red button located near the control board.
5. Press and hold the reset button for 10 seconds.
6. Plug the dryer back in and run a test cycle to make sure the code has been cleared.
In conclusion, clearing cl code on an LG dryer is a relatively easy process. First, unplug the dryer from the wall outlet. Then, press and hold the Start/Pause button for 3 seconds. Finally, plug the dryer back into the wall outlet and press the Start/Pause button again. The cl code should now be cleared and the dryer should be ready for use.