Changing the water filter on your Whirlpool refrigerator is an important part of keeping it running smoothly and efficiently. It’s a simple process that can be done in a few easy steps. First, locate the water filter in the top right corner of the refrigerator. You may need to remove the kick plate or grille at the bottom of the refrigerator to access the filter. Once you have located the filter, twist it counter-clockwise to remove it. Next, insert the new filter into the filter housing, making sure it is securely in place. Finally, twist the filter clockwise until it is firmly locked in place. Once you have replaced the filter, run water through it for about 5 minutes to flush out any air bubbles. Your Whirlpool refrigerator is now ready to use with the new filter!
How To Change The Water Filter On My Whirlpool Refrigerator
1. Locate the water filter. It is usually located in the upper-right corner of the refrigerator, behind the kickplate.
2. Turn off the water supply. This is usually done by turning the valve located behind the refrigerator.
3. Remove the old filter. Twist it counter-clockwise to loosen it, then pull it out.
4. Insert the new filter. Push it in until it is firmly seated.
5. Turn on the water supply. Open the valve to allow water to flow through the filter.
6. Flush the filter. Run the water for several minutes to flush out any air or debris.
7. Reset the filter indicator. Most models have a filter indicator light that will need to be reset. Refer to the user manual for instructions on how to do this.
Replacing the water filter on your Whirlpool refrigerator is an easy task that can be completed in a few simple steps. First, locate the filter and unscrew it from its housing. Next, remove the old filter and discard it. Then, insert the new filter into the housing and tighten the screws. Finally, run water through the filter for a few minutes to flush out any debris. With these steps, you can easily replace the water filter on your Whirlpool refrigerator and enjoy clean, filtered water.