Changing the water filter in your Electrolux refrigerator is an important part of maintaining your appliance. It is recommended that you change the filter every six months or when the filter indicator light turns on. This guide will walk you through the steps of replacing the water filter in your Electrolux refrigerator.
Before you begin, make sure you have the correct replacement filter. You can find the correct filter for your refrigerator model number on the Electrolux website. Once you have the correct filter, follow these steps to replace the water filter in your Electrolux refrigerator:
1. Locate the filter. It is typically located in the upper right-hand corner of the refrigerator, behind the grille.
2. Turn off the water supply to the refrigerator. This is usually done by turning the valve located behind the refrigerator.
3. Remove the old filter. This is done by turning the filter counterclockwise until it is released from the filter housing.
How To Chage Water Filter Electrolux Refrigerator
Changing the water filter in an Electrolux refrigerator is a simple process that can be done in just a few minutes. First, locate the filter in the back of the refrigerator, near the top. Then, twist the filter counterclockwise to remove it. Install the new filter by pushing it into the filter housing and turning it clockwise until it is secure. Lastly, reset the filter indicator light by pressing and holding the reset button for three seconds. After the filter has been changed, discard the old filter and enjoy the fresh, filtered water.
How To Chage Water Filter Electrolux Refrigerator
1. Locate the filter access door. This is usually located on the inside wall of the refrigerator, near the top.
2. Open the filter access door. This is usually done by pressing a button or pulling a lever.
3. Remove the old filter. This is usually done by twisting the filter counter-clockwise.
4. Insert the new filter. This is usually done by aligning the arrows on the filter with the arrows on the filter housing and twisting the filter clockwise.
5. Close the filter access door.
6. Reset the filter indicator light. This is usually done by pressing and holding the reset button for 3-5 seconds.
In conclusion, changing the water filter in an Electrolux refrigerator is a fairly straightforward process. First, locate the filter and unscrew the cap. Then, remove the filter and discard it. Next, insert the new filter and replace the cap. Finally, reset the filter indicator light and run water through the filter to flush out any air bubbles. Following these steps should ensure that your Electrolux refrigerator’s water filter is changed successfully.