If your Haier washer is not starting, it may be due to a faulty lid lock switch. Fortunately, it is possible to bypass the lid lock switch on your Haier washer. This guide will walk you through the steps to bypass the lid lock switch.
First, locate the lid lock switch on the washer. It is usually located near the lid, and it is typically a small black switch with two wires attached. Next, disconnect the two wires from the lid lock switch. Once the wires are disconnected, you can use a pair of needle nose pliers to twist the two wires together. This will effectively bypass the lid lock switch. Finally, reconnect the two wires to the washer. Make sure that the connections are secure and that the wires are not touching each other. Once you have completed these steps, you should be able to start your Haier washer without any issues.
How To Bypass Lid Lock Switch On Haier Washer
The lid lock switch on a Haier washer can be bypassed by disconnecting the power supply to the washer, unscrewing the lid lock switch, and then reconnecting the power supply. The lid lock switch is located on the back of the washer and is usually secured with two screws. Once the screws are removed, the lid lock switch can be disconnected from the power supply and reconnected. This will bypass the lid lock switch and allow the washer to operate without it. It is important to note that bypassing the lid lock switch can be dangerous and should only be done if absolutely necessary.
How To Bypass Lid Lock Switch On Haier Washer
1. Unplug the power cord from the wall outlet.
2. Open the lid and locate the lid lock switch.
3. Use a flathead screwdriver to gently pry the lid lock switch out of the washer.
4. Disconnect the two wires connected to the lid lock switch.
5. Reconnect the two wires to bypass the lid lock switch.
6. Plug the power cord back into the wall outlet.
7. Close the lid and test the washer to make sure it is functioning properly.
The best way to bypass the lid lock switch on a Haier washer is to disconnect the lid switch from the control board. This can be done by removing the screws that hold the switch in place and disconnecting the wires from the switch. Once the wires are disconnected, the lid lock switch is effectively bypassed. It is important to note that bypassing the lid lock switch may cause the washer to not function properly, so it is best to consult a qualified technician before attempting this.