If you have an Electrolux washer with a lid lock switch and you need to bypass it, then this guide will help you. The lid lock switch is designed to prevent the washer from operating if the lid is open. This is a safety feature, but it can be inconvenient if you need to access the washer’s interior for any reason. Fortunately, there is a way to bypass the lid lock switch on Electrolux washers.
First, you will need to locate the lid lock switch. It is usually located on the control panel of the washer. Once you have located the switch, you will need to unplug the washer from the wall. This will ensure that the washer does not turn on while you are bypassing the lid lock switch. Next, you will need to remove the control panel from the washer. You can do this by unscrewing the screws on the back of the panel.
How To Bypass Lid Lock Switch On Electrolux Washer
The lid lock switch on an Electrolux washer can be bypassed by unplugging the washer and removing the top panel. Once the top panel is removed, locate the lid lock switch and disconnect the wires from it. Reattach the wires to the lid switch and plug the washer back in. The lid lock switch will now be bypassed and the washer will operate normally.
How To Bypass Lid Lock Switch On Electrolux Washer
1. Unplug the washer from the wall outlet.
2. Locate the lid lock switch on the washer.
3. Use a flat screwdriver to pry off the lid switch cover.
4. Disconnect the two wires connected to the lid switch.
5. Install a jumper wire between the two terminals on the lid switch.
6. Secure the jumper wire with electrical tape.
7. Plug the washer back into the wall outlet.
8. Test the washer to make sure the lid lock is bypassed.
The best way to bypass the lid lock switch on an Electrolux washer is to remove the lid lock switch from the washer and replace it with a new one. This can be done by turning off the power to the washer, unplugging the power cord, and then unscrewing the screws that hold the lid lock switch in place. Once the screws are removed, the lid lock switch can be pulled out and replaced with a new one. This should allow the washer to operate normally without the lid lock switch.