If your Kenmore washer won’t start a cleaning cycle, it may be due to a few different things. Fortunately, there are a few ways to bypass the cleaning cycle and get your washer running again. To bypass the cleaning cycle on a Kenmore washer, you’ll need to reset the washer, check the water supply, and check the lid switch. Once these steps are complete, your washer should be able to bypass the cleaning cycle and get back to normal.
How To Bypass Cleaning Cycle On Kenmore Washer
If you own a Kenmore washer and want to bypass the cleaning cycle, you can do so by pressing the “Cancel/Drain” button on the control panel. This will stop the cleaning cycle and allow you to proceed with the regular wash cycle. You may also need to press the “Start/Pause” button to reset the washer. This will allow you to select the desired wash cycle and start the washing process. If the washer does not respond, you may need to unplug the power cord and plug it back in to reset the machine. Following these steps should help you bypass the cleaning cycle on your Kenmore washer.
How To Bypass Cleaning Cycle On Kenmore Washer
1. Unplug the washer from the wall outlet.
2. Locate the control panel on the washer.
3. Press and hold the “Start/Pause” button and the “Signal” button at the same time for 3 seconds.
4. Release the buttons and press the “Signal” button again.
5. The washer should now be bypassed and ready to be used.
The best way to bypass the cleaning cycle on a Kenmore washer is to unplug the washer from the power source and then press and hold the “Start/Pause” button for five seconds. This will reset the washer and allow you to start a new cycle without going through the cleaning cycle. It is important to note that this method may not work on all Kenmore washers, so it is best to consult the owner’s manual for specific instructions.