If your Amana washing machine is leaking from the bottom, it may be due to a worn out seal. Replacing the seal is a relatively simple repair that can be done in a few steps. First, you will need to unplug the washing machine and turn off the water supply. Next, you will need to remove the screws that hold the bottom panel in place and remove the panel. Once the panel is removed, you will be able to access the seal. To remove the seal, use a flat head screwdriver to pry the seal away from the machine. Once the seal is removed, you will need to clean the area where the seal was located. Finally, you will need to install the new seal. Make sure the seal is properly aligned and press it into place. Reattach the bottom panel and turn the water supply back on. Your Amana washing machine should now be sealed and ready to use.
How Do You Replace The Seal In The Bottom Of A Amana Washing Machine
Replacing the seal in the bottom of an Amana washing machine is a relatively simple process. First, unplug the machine and turn off the water supply. Then, remove the screws that hold the access panel in place and lift the panel off. Next, remove the old seal and clean the area around it. Finally, place the new seal in place and secure it with screws. Once the seal is in place, replace the access panel and secure it with screws, then turn the water supply back on and plug the machine in.
How Do You Replace The Seal In The Bottom Of A Amana Washing Machine
1. Unplug the washer from the wall outlet.
2. Turn off the water supply to the washer.
3. Move the washer away from the wall and remove the back panel.
4. Locate the old seal and remove it.
5. Clean the surface of the washer where the new seal will be installed.
6. Place the new seal on the washer and press it into place.
7. Reattach the back panel and move the washer back into place.
8. Turn on the water supply to the washer.
9. Plug the washer back into the wall outlet.
Replacing the seal in the bottom of an Amana washing machine is a relatively simple task. With the right tools and some basic knowledge of how to use them, the process can be completed in a matter of minutes. All that is required is to remove the screws that hold the seal in place, replace the old seal with a new one, and then reattach the screws. With the seal replaced, your Amana washing machine should be working as good as new.