Removing the filter from your Whirlpool AD25DSS dehumidifier is a relatively simple process. First, locate the filter access panel on the back of the unit. This panel is usually located on the lower right side of the dehumidifier. Once you’ve located the panel, open it by pressing down on the tab that is located on the side of the panel. Once the panel is open, you will be able to access the filter. To remove the filter, simply pull it out of the unit. Be sure to dispose of the filter properly, as it cannot be reused. After the filter has been removed, you can replace it with a new one.
How Do I Remove Filter For Ad25Dss Whirlpool Dehumidifier
1. Unplug the dehumidifier from the power source.
2. Remove the front panel of the dehumidifier by unscrewing the screws located on the top and bottom of the panel.
3. Locate the filter, which is typically located behind the front panel.
4. Pull the filter out of the dehumidifier.
5. Rinse the filter with warm water and a mild detergent.
6. Allow the filter to air dry completely before reinserting it into the dehumidifier.
7. Replace the front panel and secure the screws.
8. Plug the dehumidifier back into the power source.
In conclusion, to remove the filter for the AD25DSS Whirlpool Dehumidifier, you should first unplug the unit from the wall outlet. Then, locate the filter access panel on the back of the unit and open it. Remove the filter by grasping it firmly and pulling it out. Clean the filter with warm water and a mild detergent, and then rinse it thoroughly. Allow the filter to dry completely before reinstalling it back into the unit.