If your LG dehumidifier is freezing up, it is likely due to a faulty freeze sensor. Fortunately, it is possible to bypass the freeze sensor on your LG dehumidifier in order to get it running again. The process is relatively simple and can be done with a few basic tools. First, you will need to locate the freeze sensor on your dehumidifier. This is typically located near the evaporator coils. Once you have located the freeze sensor, you can then disconnect it from the circuit board. Once disconnected, you can then bypass the freeze sensor by connecting a jumper wire between the two terminals on the circuit board. This will effectively bypass the freeze sensor and allow your dehumidifier to run again.
How Can I Bypass The Freeze Sensor On My Lg Dehumidifier
Unfortunately, it is not possible to bypass the freeze sensor on an LG dehumidifier. The freeze sensor is an important safety feature that helps prevent the dehumidifier from operating in temperatures that are too cold, which can cause damage to the unit.
How Can I Bypass The Freeze Sensor On My Lg Dehumidifier
1. Unplug the dehumidifier from the power source.
2. Remove the back panel of the dehumidifier.
3. Locate the freeze sensor. It should be a small round disc-like object connected to the control board.
4. Disconnect the wires from the freeze sensor.
5. Connect a jumper wire between the two pins on the freeze sensor.
6. Replace the back panel of the dehumidifier.
7. Plug the dehumidifier back into the power source.
8. Turn the dehumidifier on and check to see if it is working properly.
In conclusion, the best way to bypass the freeze sensor on your LG dehumidifier is to check the air filter, clean the condensate drain, and make sure the dehumidifier is in a well-ventilated area. If these steps do not resolve the issue, then you may need to replace the freeze sensor or contact a professional for assistance.