Removing a water filter from a Maytag refrigerator is a simple process that can be done in just a few steps. First, locate the water filter in the upper right-hand corner of the refrigerator. Next, turn the filter to the left and pull out. If the filter is stuck, you may need to use a pair of pliers to loosen it. Once the filter is out, discard it and replace it with a new filter. Make sure to follow the manufacturer’s instructions for installation and use of the new filter.
How To Remove Water Filter From Maytag Refrigerator
1. Locate the water filter. It is usually located in the grille at the bottom of the refrigerator, or in the upper right corner of the refrigerator.
2. Unscrew the filter cap. You may need a flathead screwdriver or a coin to do this.
3. Pull the filter out of the refrigerator.
4. Dispose of the old filter properly.
5. Install the new filter. Line up the arrows on the filter and the cap, then twist the cap back on.
6. Run water through the filter for 3 minutes to flush out any air bubbles.
7. Reset the filter indicator light (if applicable).
Removing the water filter from a Maytag refrigerator is a relatively simple process. First, locate the filter in the back of the refrigerator and press the filter release button. Next, turn the filter counterclockwise to remove it. Finally, discard the old filter and replace it with a new one. With a few simple steps, you can easily remove the water filter from your Maytag refrigerator.