Why Won’T My Maytag Washer Start

If your Maytag washer won’t start, it can be very frustrating. There are a few common reasons why your Maytag washer won’t start, such as a faulty lid switch, a broken belt, or a broken motor. Before you call a repairman, it’s important to troubleshoot the problem to determine the cause. In this guide, we’ll walk you through the steps to diagnose and fix the issue so you can get your Maytag washer up and running again.

Why Won’T My Maytag Washer Start

If your Maytag washer won’t start, there could be several potential causes. The most common causes include a power issue, a faulty lid switch, an issue with the timer, a problem with the water level switch, or a faulty motor. Make sure the washer is plugged in and the outlet is functioning properly. Check the lid switch to make sure it is working properly. If the timer is stuck, try resetting it. If the water level switch is faulty, it may need to be replaced. Finally, if the motor is not working, it may need to be replaced.

Why Won’T My Maytag Washer Start

1. Check the power source – Make sure the power cord is plugged into a working outlet and that the circuit breaker or fuse for the washer is not tripped.

2. Check the door latch – Make sure the door latch is securely closed.

3. Check the water supply – Make sure the water supply to the washer is turned on and that there are no kinks in the hoses.

4. Check the control panel – Make sure the control panel is set to the correct cycle and that all the buttons are properly engaged.

5. Check the drain hose – Make sure the drain hose is not clogged and that it is securely connected to the drain pipe.

6. Check the motor – If the motor is not running, you may need to reset the motor or replace it.

In conclusion, there are a variety of reasons why your Maytag washer may not start. It could be due to a power issue, a faulty lid switch, a broken drive belt, or a defective timer. If you have checked all of these components and the washer still won’t start, it is likely a more serious problem and you should contact a qualified technician for assistance.