If you’re having trouble with your Maytag washer, you may need to reset the sensor. Resetting the sensor can help to restore normal operation and can help to resolve some common issues. This guide will explain how to reset the sensor on your Maytag washer.
First, unplug the washer from the power source. This will ensure that the washer is completely powered off and will prevent any potential damage to the washer. Next, locate the control panel on the washer. This is usually located on the front or top of the washer. Once you have located the control panel, press and hold the “Start/Pause” button for 3 seconds. This will reset the sensor and the washer should now be operational. If the problem persists, you may need to contact a qualified technician for further assistance.
Popular: What Does Ofb Mean On A Maytag Washer
How Do You Reset The Sensor On A Maytag Washer
To reset the sensor on a Maytag washer, first unplug the washer from the power source. Then press and hold the Start/Pause and the Cancel/Drain buttons at the same time for 3 seconds. This will reset the washer and the sensor should now be reset.
Recommended: Maytag Front Load Washer Where To Put Detergent
How Do You Reset The Sensor On A Maytag Washer
1. Unplug the washer from the wall outlet.
2. Locate the water level pressure switch, which is located at the back of the washer near the bottom.
3. Unscrew the two screws that hold the pressure switch in place.
4. Remove the pressure switch and disconnect the two wires.
5. Use a needle-nose pliers to remove the plastic cap from the pressure switch.
6. Insert a small flathead screwdriver into the hole and turn it counterclockwise until you feel a click.
7. Reconnect the two wires and re-screw the pressure switch back into place.
8. Plug the washer back into the wall outlet.
9. Run a cycle to test the sensor.
Suggested: How To Turn Off Control Lock On Maytag Washer
In conclusion, resetting the sensor on a Maytag washer is a relatively simple process. First, unplug the washer from the power source and wait for a few minutes. Then, press and hold the Start/Pause button for three seconds. Finally, plug the washer back in and wait for the washer to reset itself. Following these steps should help you reset the sensor on your Maytag washer.