Hotpoint washers are a popular choice for many households, but when the self-clean light starts blinking, it can be a source of frustration. This may be due to a variety of reasons, including a faulty washer, a blocked filter, or a malfunctioning pump. Fortunately, troubleshooting this issue is relatively straightforward and can be done quickly in order to get your washer back up and running. By understanding the causes of this issue and following the steps outlined below, you can easily get your Hotpoint washer back to its best.
Why Hotpoint Washer Self Clean Light Blinking
Hotpoint washer self clean light blinking is a common issue that can occur when the washer is not draining properly. This can be caused by a variety of issues such as a clogged drain, a faulty pump, or a faulty water level switch. In order to fix this issue, it is important to first identify the cause of the blinking light and then take the necessary steps to resolve it. This could include unclogging the drain, replacing the pump, or replacing the water level switch. Once the issue is resolved, the blinking light should stop and the washer should be able to self-clean properly.
Why Hotpoint Washer Self Clean Light Blinking
1. Unplug the washer from the power source.
2. Check the drain hose connection to make sure it is secure.
3. Check the water supply hoses to make sure they are connected and there are no kinks or blockages.
4. Make sure the water supply valves are open and the pressure is adequate.
5. Run a cycle with a cup of white vinegar to clean the inside of the washer.
6. Check the filter for any blockages or debris.
7. Check the drain pump for any blockages or debris.
8. Check the drain hose for any blockages or debris.
9. Check the washer door for any blockages or debris.
10. Check the washer lid switch for any blockages or debris.
11. Check the control panel for any error codes or messages.
12. Reset the washer by pressing and holding the start/pause button for 5 seconds.
Hotpoint washer self clean light blinking is a common issue that can be caused by a variety of reasons. It is important to identify the cause of the issue and take the necessary steps to resolve it. The most common causes of the blinking light are a faulty water valve, a faulty temperature sensor, a faulty timer, or a faulty control board. It is important to troubleshoot the issue and replace any faulty parts to get the washer working properly again.