How To Drain Samsung Washer

If your Samsung washer is not draining properly, you may need to drain it manually. This guide will show you how to safely drain your Samsung washer. Before you begin, make sure to unplug the washer from the wall, and turn off the water supply. You will also need a bucket or other container to collect the water.

First, locate the drain hose at the back of the washer. This is usually a flexible hose that runs from the back of the washer to the drain pipe. If the hose is connected to the drain pipe, carefully disconnect it. If the hose is not connected, you can skip this step.

Next, place your bucket or container underneath the drain hose. Slowly tilt the washer forward to allow the water to drain out into the bucket. You may need to tilt the washer several times to completely drain it. Once the water has stopped draining, you can move the washer back into its original position.

 

 

How To Drain Samsung Washer

1. Unplug the washer from the wall outlet.

2. Turn off the water supply valves.

3. Place a bucket or pan underneath the washer to catch any water that may drain out.

4. Locate the drain hose on the back of the washer and disconnect it from the wall or drain pipe.

5. Place the end of the drain hose in the bucket or pan.

6. Turn the washer to the spin cycle and let it run until all the water is drained.

7. Once the water has drained, turn off the washer and disconnect the drain hose from the bucket or pan.

8. Reconnect the drain hose to the wall or drain pipe.

9. Turn on the water supply valves.

10. Plug the washer back into the wall outlet.

The most efficient way to drain a Samsung washer is to disconnect the water supply hoses and allow the water to flow out of the washer. If the washer is connected to a standpipe, the drain hose should be disconnected and the water allowed to flow out of the standpipe. If the washer is connected to a sink, the drain hose should be disconnected and the water allowed to flow out of the sink. Once the water has been drained, the hoses should be reconnected and the washer is ready for use.