If you have a Crosley dishwasher and you need to put it in diagnostic mode, the process is relatively simple. First, you will need to locate the diagnostic mode switch on the dishwasher. This switch is usually located on the bottom of the dishwasher, near the front. Once you have located the switch, press and hold it for three seconds. This will activate the diagnostic mode. The dishwasher will then run a series of tests and display the results on the display panel. It is important to follow the instructions on the display panel to ensure the dishwasher is functioning correctly. After the diagnostic mode is complete, press the switch again to return the dishwasher to its normal operating mode.
How To Put Crosley Dishwasher In Diagnostic Mode
To put a Crosley dishwasher into diagnostic mode, first locate the diagnostic mode button on the dishwasher’s control panel. This button is usually labeled “Diagnostic Mode” or “Diagnostic Test”. Once the button is located, press and hold it for three seconds. The dishwasher should then enter diagnostic mode, indicated by a series of beeps. During diagnostic mode, the dishwasher will cycle through a series of tests to check for any errors or malfunctions. Once the tests are completed, the dishwasher will return to normal operation. If any errors are found, they will be displayed on the control panel.
How To Put Crosley Dishwasher In Diagnostic Mode
1. Unplug the dishwasher from the power source.
2. Press and hold the “Start/Reset” and “Cancel/Drain” buttons simultaneously.
3. Plug the dishwasher back into the power source while still holding the two buttons.
4. Release the buttons when the “Active” light begins to flash.
5. Press the “Start/Reset” button once to enter diagnostic mode.
6. Press the “Cancel/Drain” button twice to enter the specific diagnostic mode for the dishwasher.
7. Press the “Start/Reset” button to cycle through the various diagnostic codes.
8. Press the “Cancel/Drain” button to exit the diagnostic mode.
In conclusion, putting a Crosley dishwasher into diagnostic mode is a relatively easy process. All that needs to be done is to turn off the power to the dishwasher, press and hold the start button, turn the power back on, and then press the start button again. This will put the dishwasher into diagnostic mode and allow you to troubleshoot any issues that may be occurring.