If your Whirlpool dehumidifier is not working properly, you may need to reset it. Resetting your dehumidifier can help restore it to its original settings and help it run more efficiently. Resetting your Whirlpool dehumidifier is easy and can be done in just a few steps.
First, make sure that your dehumidifier is unplugged from the wall. Then, locate the reset button on the back of the dehumidifier. It should be a small button with a red circle around it. Press and hold the reset button for 10 seconds. After 10 seconds, release the button and plug the dehumidifier back into the wall.
Your dehumidifier should now be reset and ready to use. If you have any further questions or need more help, please consult your owner’s manual or contact Whirlpool customer service.
How To Reset Whirlpool Dehumidifier
1. Unplug the dehumidifier from the power source.
2. Remove the filter from the unit.
3. Clean the filter with warm soapy water and rinse thoroughly.
4. Replace the filter in the unit.
5. Plug the dehumidifier back into the power source.
6. Press and hold the “Reset” button for 5 seconds.
7. Set the desired humidity level and the fan speed.
8. Turn the dehumidifier on and enjoy the fresh air.
How To Reset Whirlpool Dehumidifier
In conclusion, resetting a Whirlpool dehumidifier is a relatively simple task. First, unplug the dehumidifier from the wall outlet and wait for at least 30 seconds before plugging it back in. Then, press and hold the reset button for at least three seconds. Finally, press the power button to turn the dehumidifier back on. Following these steps should reset the dehumidifier and restore it to its original settings.