Removing the control panel on a Kenmore washing machine is a relatively simple task that can be accomplished in a few steps. First, unplug the machine from the wall outlet and shut off the water supply. Next, remove the screws that hold the control panel in place and carefully lift the panel off. Once the panel is removed, you will be able to access the wiring and other components inside the machine. Be sure to take note of where the wires are connected so that you can reconnect them properly when you are finished. Finally, replace the control panel and reattach the screws before plugging the machine back in and turning on the water supply. With these steps, you should be able to easily remove the control panel from your Kenmore washing machine.
How To Remove Kenmore Washing Machine Control Panel
Removing the control panel from a Kenmore washing machine is a relatively simple process. First, unplug the washing machine from the wall outlet. Then, locate the two screws on the back of the control panel and remove them. Once the screws are removed, carefully pull the control panel away from the machine. There may be some wires attached to the back of the panel, so be sure to disconnect them before completely removing the panel. Once the panel is removed, you can access the internal components of the washing machine for repair or maintenance.
How To Remove Kenmore Washing Machine Control Panel
1. Unplug the washing machine from the wall outlet.
2. Locate the screws that hold the control panel in place.
3. Remove the screws and carefully pull the control panel away from the machine.
4. Disconnect the wiring harness from the back of the control panel.
5. Set the control panel aside.
6. Remove any remaining screws that may be holding the control panel in place.
7. Carefully lift the control panel away from the machine and set it aside.
Removing the control panel on a Kenmore washing machine is a straightforward process that requires basic tools and a few minutes of time. First, unplug the machine from the wall outlet and turn off the water supply. Then, remove the screws that secure the control panel to the machine. Carefully lift the panel off and disconnect the wiring harness. Finally, remove the screws that secure the control panel to the frame and lift it away. With the control panel removed, you can now access the internal components of the machine for repairs or maintenance.