Testing the motor on a Kenmore washer is a relatively simple process. First, you will need to unplug the washer from the wall. Then, you will need to remove the back panel of the washer in order to access the motor. Once the motor is exposed, you can use a multimeter to test the motor for continuity. You should also check the motor’s capacitors for any signs of damage. Finally, you can use a voltmeter to measure the voltage of the motor. If all of these tests check out, then the motor is likely in working condition.
How To Test Motor On Kenmore Washer
Testing the motor on a Kenmore washer is a relatively simple process. First, unplug the washer from the wall outlet. Then, locate the motor and remove the wires from the motor terminals. Using a multimeter, set the meter to the ohms setting and test the resistance of the motor windings. If the resistance is within the manufacturer’s specifications, the motor is functioning properly. If the resistance is too low or too high, the motor needs to be replaced. After testing the motor, reattach the wires to the motor terminals and plug the washer back in.
How To Test Motor On Kenmore Washer
1. Unplug the washer from the wall outlet.
2. Remove the back panel of the washer to access the motor.
3. Check the motor for any visible signs of damage or corrosion.
4. Test the motor with a multimeter to check the continuity of the windings.
5. If the motor passes the continuity test, check the motor capacitor for any signs of damage.
6. Test the motor capacitor with a multimeter to check the capacitance.
7. If the motor and capacitor pass the tests, reassemble the washer and plug it back into the wall outlet.
8. Start a cycle and observe the motor to make sure it is operating correctly.
Testing the motor on a Kenmore washer is a straightforward process. First, unplug the washer and remove the back panel. Check the motor for any visible damage or loose wires. Next, test the motor with a multimeter to make sure it is receiving power and that the windings are not shorted. Finally, check the belt and pulley to make sure they are in good condition and not slipping. If all of these tests pass, the motor should be functioning correctly.