If you have a Whirlpool Duet washer and you need to replace the drain pump, you can do so with a few simple tools and a bit of patience. This guide will walk you through the steps necessary to replace the drain pump on your Whirlpool Duet washer. Before starting, make sure you have all of the necessary tools and parts. You will need a flat-head screwdriver, a Phillips-head screwdriver, a pair of pliers, and a new drain pump. Once you have all of the necessary tools and parts, you can begin the process of replacing the drain pump.
How To Replace Drain Pump On Whirlpool Duet Washer
1. Unplug the washer from the power source.
2. Remove the front panel of the washer by unscrewing the screws located on the bottom of the washer.
3. Remove the drain hose from the pump by pulling it off.
4. Unscrew the mounting screws that hold the pump in place.
5. Pull the pump out of the washer.
6. Install the new pump by reversing the steps.
7. Reattach the drain hose to the pump.
8. Replace the front panel and screws.
9. Plug the washer back into the power source.
How To Replace Drain Pump On Whirlpool Duet Washer
Replacing the drain pump on a Whirlpool Duet washer is a relatively straightforward process. With the right tools and a bit of patience, the entire process can be completed in about an hour. First, unplug the washer and remove the back panel. Then, disconnect the hoses and wires from the pump and remove the pump from the washer. Finally, install the new pump and reconnect the hoses and wires. After that, replace the back panel, plug the washer back in, and you’re done.