Changing a heating element in a Kenmore dryer is a relatively simple process. It is important to note that the process may vary slightly depending on the model of the dryer. The following steps will provide a general guide on how to change a heating element in a Kenmore dryer. Before beginning, it is important to ensure that the power to the dryer is disconnected. Additionally, it is important to have the necessary tools and replacement parts on hand before beginning the process.
1. Start by removing the back panel of the dryer. This will provide access to the heating element.
2. Disconnect the wires from the heating element.
3. Remove the screws that hold the heating element in place.
4. Carefully remove the heating element from the dryer.
5. Install the new heating element in the same position as the old one.
6. Reattach the wires to the new heating element.
How To Change A Heating Element In A Kenmore Dryer
Changing a heating element in a Kenmore dryer is a relatively easy task. First, unplug the dryer from the wall and remove the back panel. Then, locate the heating element and disconnect the wires from the terminals. Next, remove the mounting screws that secure the element to the dryer. Pull the element out and replace it with the new one. Secure the new element with the mounting screws and reconnect the wires to the terminals. Finally, replace the back panel and plug the dryer back into the wall.
How To Change A Heating Element In A Kenmore Dryer
1. Unplug the dryer from the wall outlet and shut off the gas valve if applicable.
2. Remove the back panel of the dryer.
3. Disconnect the wires that are connected to the heating element.
4. Remove the mounting screws that hold the heating element in place.
5. Remove the old heating element and replace it with the new one.
6. Reattach the wires to the new heating element.
7. Replace the back panel and secure it with the screws.
8. Plug the dryer back into the wall outlet and turn on the gas valve if applicable.
9. Test the dryer to make sure the heating element is working properly.
Changing a heating element in a Kenmore dryer is not a difficult task. With the right tools and a little bit of knowledge, anyone can do it. First, unplug the dryer and remove the back panel. Then, disconnect the wires from the heating element and remove the mounting screws. Finally, install the new heating element and reconnect the wires. With these simple steps, you can easily replace the heating element in your Kenmore dryer.