If your Kenmore dryer has a check filter light, it’s important to reset it after cleaning the lint filter. Resetting the check filter light will ensure that your dryer is running efficiently and safely. To reset the check filter light on your Kenmore dryer, follow these simple steps:
1. Unplug the dryer from the wall outlet.
2. Remove the lint filter and clean it thoroughly.
3. Replace the lint filter and plug the dryer back into the wall outlet.
4. Press and hold the “Filter Reset” button for three seconds.
5. The check filter light should now be reset and the dryer is ready to use.
How To Reset Kenmore Dryer Check Filter
Resetting a Kenmore dryer is a simple process that can be completed in a few steps. First, unplug the dryer from the wall outlet and remove the lint filter. Inspect the filter for any clogs or debris that may be blocking the airflow. If there are any clogs, clear them away and reinsert the filter. Next, locate the reset button, which is usually located on the back of the dryer near the bottom. Press and hold the reset button for a few seconds until the dryer turns on. Finally, plug the dryer back into the wall outlet and turn it on. The reset process is now complete.
How To Reset Kenmore Dryer Check Filter
1. Unplug the dryer from the wall outlet.
2. Open the dryer door and locate the lint filter.
3. Remove the lint filter and clean it thoroughly.
4. Replace the lint filter and close the dryer door.
5. Plug the dryer back into the wall outlet.
6. Press and hold the “Start/Pause” button for five seconds.
7. Release the “Start/Pause” button and the check filter light should be reset.
In conclusion, resetting the Kenmore dryer check filter is a relatively simple process. First, unplug the dryer from the wall outlet and remove the lint filter. Then, press and hold the start/pause button for three seconds until the control panel lights up. Finally, press the start/pause button again to reset the filter. Following these steps should reset the filter and allow the dryer to work properly again.