If you have an Electrolux washer and you need to bypass the cleaning cycle, it is possible to do so with a few simple steps. First, you will need to locate the control panel on the washer. This is usually located on the top or side of the washer. Next, you will need to press the “Power” button to turn the washer on. Once the washer is on, you will need to press the “Cycle Select” button until the desired cycle is selected. Finally, press and hold the “Start/Pause” button for 3 seconds to bypass the cleaning cycle. Your washer is now ready for use.
How To Bypass Cleaning Cycle On Electrolux Washer
If your Electrolux washer is stuck in a cleaning cycle, you can bypass it by pressing and holding the “Start/Pause” button for three seconds. This will reset the washer and allow you to select a new cycle. If the washer is still stuck in the cleaning cycle, you can unplug the power cord and wait for 30 seconds before plugging it back in. This should reset the washer and allow you to select a new cycle. If the washer is still stuck, you can try resetting the control board. To do this, locate the control board and press and hold the “Start/Pause” button for three seconds. This should reset the board and allow you to select a new cycle.
How To Bypass Cleaning Cycle On Electrolux Washer
1. Unplug the washer from the power source.
2. Press and hold the “Start/Pause” button for 3 seconds.
3. Press the “Delay Start” button until the “Clean” light flashes.
4. Press the “Start/Pause” button to bypass the cleaning cycle.
5. Plug the washer back into the power source.
In conclusion, the best way to bypass the cleaning cycle on an Electrolux washer is to unplug the washer, press and hold the start/pause button for five seconds, and then plug the washer back in. This should reset the washer and allow you to bypass the cleaning cycle. However, it is important to note that this method may not work on all Electrolux washers, so it is best to consult the user manual for specific instructions.